Revision › Purity, formulations and chromatography › Worksheet

Purity, formulations and chromatography Hard

GCSE Chemistry · Chemical Analysis · Name ____________________ Date ________

Builds on: Atoms, elements, compounds and mixtures, The periodic table, Transition metals

Do now

Quick questions on earlier topics - to get your brain going.

  1. A nitrogen atom has a relative atomic mass of 14 and an atomic number of 7. How many neutrons are in one nitrogen atom? [1]

  2. A sodium atom has an atomic number of 11 and a relative atomic mass of 23. How many neutrons are in one sodium atom? [1]

  3. The most reactive halogen that can displace any other from its salt solution is which element? [1]

  4. Elements that tend to form positive ions are called what? [1]

Practice

  1. During chromatography you observe two spots with Rf values 0.45 and 0.78 respectively. Which of the following statements below is a common misunderstanding? Answer: b [1]

    1. A higher Rf value means the substance has lower affinity for the paper.
    2. Both spots must belong to the same pure compound.
    3. The solvent front cannot be used to calculate Rf if it moves unevenly.
    4. The colour of the spot determines its Rf value.
  2. A student uses paper chromatography to separate pigments extracted from a leaf. Which of the following best describes what will be observed? Answer: b [1]

    1. Only one spot because all pigments have identical Rf values.
    2. Multiple coloured spots, each with distinct Rf values.
    3. The solvent front will dissolve all pigments into a single cloud.
    4. Pigments will not travel on the paper as they are too large.
  3. A chromatography experiment gives an Rf value of 0.55 for compound Y. If the solvent front travelled 12 cm, how far from the origin did compound Y travel? Give your answer in millimetres to the nearest millimetre. Answer: 66 [2]

  4. Which of the following statements is true regarding melting points of pure substances? Answer: a [1]

    1. The melting point does not depend on atmospheric pressure.
    2. Pure substances always melt at a single temperature.
    3. Mixtures have sharp melting points but pure substances melt over a range.
    4. A pure substance’s boiling point can be lower than its melting point.
  5. A sample of pure compound X has been run on paper chromatography. The centre of the spot moved 3.6 cm while the solvent front travelled 9.0 cm. Calculate the Rf value of compound X to two decimal places. Answer: 0.40 [2]

  6. Which of the following safety measures is essential when performing paper chromatography with ethanol as the solvent? Answer: a [1]

    1. Wear gloves only if you have allergic skin reactions.
    2. Conduct the experiment in a well‑ventilated area.
    3. Use a plastic stand to hold the chromatography paper.
    4. Store all used solvents in metal containers regardless of composition.
  7. Which statement best distinguishes a pure substance from an impure mixture using melting point data? [1]

    1. A pure substance melts at the same temperature in all conditions; an impure sample will not melt.
    2. A pure substance has a single, sharp melting point; an impurity gives a higher melting point.
    3. A pure substance has a single, narrow melting point; an impure sample shows a broader range or depressed temperature.
    4. A pure substance shows a range of temperatures; an impurity has a precise temperature.
  8. Which of the following statements is correct regarding a pure substance? [1]

    1. All its molecules have identical composition.
    2. It melts at a single temperature only when heated in vacuum.
    3. Its boiling point can be lowered by adding another liquid.
    4. It contains more than one element or compound.
  9. Which of the following is a necessary precaution when performing paper chromatography with organic solvents that are flammable? [1]

    1. Perform the experiment under water.
    2. Ensure the work area is well ventilated and keep flame sources away.
    3. Wear a face mask to protect from vapours.
    4. Use a metal tray for the solvent.
  10. During paper chromatography two coloured spots, X and Y, move to distances of 2.0 cm and 3.5 cm respectively when the solvent front reaches 7.0 cm. The same experiment is repeated with a different solvent; spot X moves to 1.8 cm while spot Y remains at 3.4 cm. Which spot most likely corresponds to a pure compound? Choose: [1]

    1. Spot Y
    2. Spot X
    3. Neither spot is pure.
    4. Both spots are pure.
  11. Which of the following is a common misconception about determining purity from melting point? [1]

    1. A lower melting point indicates higher purity.
    2. A broad melting range suggests impurities are present.
    3. A sharp single peak at the expected temperature shows a pure compound.
    4. The observed melting point must match the literature value for the substance to be pure.
  12. A student places a small droplet of an unknown dye on paper chromatography paper and runs the solvent until the solvent front reaches the top of the paper. The centre of the dye spot is found to be 3.6 cm from the origin, while the solvent front travelled 8.0 cm. Calculate the Rf value of the dye, giving your answer to two decimal places. [1]

Exam practice

Real past-paper questions on purity, formulations and chromatography, with their mark schemes, are in 4 Triangles - free to practise.

Mixed practice

Questions on topics this one links to - mixing them helps you remember both.

  1. When 0.1 M NaOH is added to a solution containing Mg²⁺ and Al³⁺, which of the following occurs? [2]

    1. B) Only Mg(OH)₂ forms a white precipitate; Al(OH)₃ dissolves in excess NaOH
    2. D) No reaction occurs
    3. C) Both dissolve forming soluble hydroxides
    4. A) Both form white precipitates that remain solid
    (Tests for ions and instrumental analysis)
  2. Sodium melts at 98 °C and chromium at 1908 °C. Find the difference in their melting points in kelvin. [2]

    (Transition metals)
  3. A student mixes 0.05 M AgNO₃ with an aqueous solution that contains both chloride and iodide ions. Which colour precipitate is observed? [2]

    1. C) Yellow
    2. A) White
    3. B) Cream
    4. D) No precipitate
    (Tests for ions and instrumental analysis)
  4. Which group of the periodic table contains the noble gases? [2]

    1. Group 1
    2. Group 7
    3. Group 17
    4. Group 0
    (The periodic table)
  5. Which of the following techniques would you use to separate a mixture of sand and iron filings? (Tick one box.) [1]

    1. Distillation
    2. Magnetic separation
    3. Filtration
    4. Chromatography
    (Atoms, elements, compounds and mixtures)
  6. A small piece of baking soda is placed inside a sealed chamber containing an unknown gas. No fizzing occurs after 5 min. Which gas is most likely present? [1]

    1. O₂
    2. H₂
    3. CH₄
    4. CO₂
    (Tests for gases)

💼 Where it leads: Quality control assistant · Water treatment worker · Laboratory technician · Forensic scientist - more

Stuck, or finished? Scan for help on purity, formulations and chromatography - an explanation, hints and unlimited practice that marks itself.
Free at 4triangles.co.uk

Answers

  1. 7
  2. 12
  3. fluorine
  4. metals
  5. B Both spots must belong to the same pure compound.
    If two different Rf values are observed, they represent two different compounds – not a single pure one. Answer: b
  6. B Multiple coloured spots, each with distinct Rf values.
    Different leaf pigments (e.g., chlorophylls, carotenoids) have different affinities for the stationary phase and thus separate into distinct spots. Answer: b
  7. 66
    Distance = Rf × distance of solvent front = 0.55 × 12 cm = 6.6 cm = 66 mm. Answer: 66
  8. B Pure substances always melt at a single temperature.
    Pure substances have a fixed, sharp melting point; mixtures melt over a temperature range. Answer: a
  9. 0.4
    Rf = \frac{distance\text{ (spot)}}{distance\text{ (solvent)}} = \frac{3.6}{9.0} = 0.4 → 0.40 to two decimal places.
  10. B Conduct the experiment in a well‑ventilated area.
    Ethanol vapour is flammable and must be handled in an adequately ventilated space. Answer: a
  11. C A pure substance has a single, narrow melting point; an impure sample shows a broader range or depressed temperature.
    Impurities broaden or lower MP; D reflects this.
  12. A All its molecules have identical composition.
    Pure substances have identical molecular composition; thus D is correct.
  13. B Ensure the work area is well ventilated and keep flame sources away.
    Flammable solvents need ventilation and no open flames.
  14. A Spot Y
    Pure compounds give the same Rf in different solvents; only Y stays nearly constant.
  15. A A lower melting point indicates higher purity.
    Lower MP usually means more impurity; so A is misconception.
  16. 0.45
  17. A B) Only Mg(OH)₂ forms a white precipitate; Al(OH)₃ dissolves in excess NaOH
  18. 1810
  19. A C) Yellow
  20. D Group 0
    Noble gases are in Group 0.
  21. B Magnetic separation
    The original list of options does not contain the physically correct method for separating sand from iron filings – that would be magnetic separation. All the other choices (filtration, distillation and chromatography) are ineffective for this solid‑solid mixture. …
  22. A O₂
    Baking soda reacts with CO₂ to produce fizz; no reaction suggests the gas is not CO₂.

Some key word definitions from Oak National Academy (Open Government Licence).

Stuck, or finished? Scan for help on purity, formulations and chromatography - an explanation, hints and unlimited practice that marks itself.
Free at 4triangles.co.uk