Bearings and measuring
Knowledge organiser · GCSE Maths · Geometry and measures
Read the full guide · Worksheets: Easy · Medium · Hard ·
Measuring lines, angles and bearings helps read maps and scale drawings.
Key words
- Bearing
- A bearing is an angle measured in degrees from North in the clockwise direction and written with three figures.
- Transversal
- A transversal is a line, line segment, or ray that intersects through two or more lines at distinct (different) points.
- Corresponding
- Corresponding angles are a pair of angles at different vertices on the same side of a transversal in equivalent positions.
- Alternate
- Alternate angles are a pair of angles, both between or both outside two line segments, that are on opposite sides of the transversal that cuts them.
- Co-interior
- Co-interior angles are on the same side of the transversal line and in between the two other lines.
- Angle
- An angle is a measure of turn. It is often displayed as the rotation between two line segments.
How to do it
- Use a ruler to measure the length of any line.
- If it’s a map, convert the measured length using the scale given.
- Read an angle with a protractor; note the degree value.
- Name the angle type – acute if <90°, right if =90°.
Watch out for
- Wrongly guessing AB’s length; remember to read directly.
- Inaccurate measurements: always measure close to the line centre.
- When scaling decimals, multiply correctly – avoid adding fractions of the scale factor.
How it links
Builds on: Constructions and loci, Angles and polygons
Leads to: Scale drawings and maps
Remember: Keep each step clear and check your units before writing the final answer.
Test yourself: scan for quick questions on this topic that mark themselves.
Free at 4triangles.co.uk
Some definitions from Oak National Academy (Open Government Licence).