Bearings and measuring

Knowledge organiser · GCSE Maths · Geometry and measures

Read the full guide · Worksheets: Easy · Medium · Hard ·

Measuring lines, angles and bearings helps read maps and scale drawings.

Key words

Bearing
A bearing is an angle measured in degrees from North in the clockwise direction and written with three figures.
Transversal
A transversal is a line, line segment, or ray that intersects through two or more lines at distinct (different) points.
Corresponding
Corresponding angles are a pair of angles at different vertices on the same side of a transversal in equivalent positions.
Alternate
Alternate angles are a pair of angles, both between or both outside two line segments, that are on opposite sides of the transversal that cuts them.
Co-interior
Co-interior angles are on the same side of the transversal line and in between the two other lines.
Angle
An angle is a measure of turn. It is often displayed as the rotation between two line segments.

How to do it

  1. Use a ruler to measure the length of any line.
  2. If it’s a map, convert the measured length using the scale given.
  3. Read an angle with a protractor; note the degree value.
  4. Name the angle type – acute if <90°, right if =90°.

Watch out for

  • Wrongly guessing AB’s length; remember to read directly.
  • Inaccurate measurements: always measure close to the line centre.
  • When scaling decimals, multiply correctly – avoid adding fractions of the scale factor.

Remember: Keep each step clear and check your units before writing the final answer.

Test yourself: scan for quick questions on this topic that mark themselves.
Free at 4triangles.co.uk

Some definitions from Oak National Academy (Open Government Licence).