Revision › GCSE Maths › Number

Rounding and error intervals

GCSE Maths · Number. Explained 2 ways - start with the one that suits you.

Rounding and error intervals Start here

You need to round carefully. Don’t change numbers before you finish your work.

Key words

round
change a number to the nearest value that is easier to use.
truncate
cut off extra digits without rounding up.
interval
a range between two limits, often written as < or >.

How to do it

  1. Find the exact result of a calculation first.
  2. If you must give a whole number, round up when there is any remainder.
  3. Do not round earlier than the last step.
  4. Use < and > to show possible error if required.

Watch out for

  • Rounding too early can give the wrong final answer.
  • Missing a remainder means you think fewer adults are enough.
  • Mixing truncation and rounding up creates confusion.

Remember: Always finish calculations before rounding. The last number you write is your rounded value.

Rounding and error intervals Core

This skill covers rounding to a required precision, keeping full‑precision data until the final step, and writing appropriate error intervals.

How to do it

  1. Keep all digits until the end of the calculation.
  2. Decide whether decimal places or significant figures are requested.
  3. Look at the digit immediately to the right of the desired place.
  4. If that digit is 5–9, increase the last kept digit by one; if 0–4 keep it unchanged.
  5. For rounding to n decimal places write <x+½·10⁻ⁿ> and >x‑½·10⁻ⁿ.
  6. For significant figures keep only the required non‑zero digits, retaining zeros between or after a decimal point.

Watch out for

  • Avoid rounding during intermediate steps; use full‑precision values until the final answer.
  • Remember that the error interval for decimal‑place rounding is ±0.5×10⁻ⁿ, not 0≤error<10⁻ⁿ unless truncating.
  • When asked for a range, give it with inequality notation rather than a single rounded number.

Remember: Always perform all calculations using the full‑precision values before rounding the final answer—do not round intermediate steps (see N14).

✏️ Try 3 quick questions

  1. Always, sometimes or never true? Rounding a whole number to the nearest ten results in a multiple of 10.

  2. A length measurement lies between 12.8 cm and 13.2 cm. What is the largest integer (whole centimetre) that could be the rounded value when rounding to the nearest centimetre?

  3. How many different values can a number rounded to the nearest 0.5 have between 10 and 20 inclusive?

Practise it with real exam questions

4 Triangles has quick questions on rounding and error intervals, real GCSE past-paper questions with their mark schemes, and a revision plan that picks what to work on next.

Try the quick questions

📝 Worksheets and a knowledge organiser to print

Questions on this topic for a lesson, homework or revision - a quick "do now", misconception questions, small steps that change one thing at a time, and practice, with answers on the last page.

Medium 📄 Knowledge organiser

🔤 Key words to know

Round
To change a number into another number that is approximately the same value but is easier to work with. E.g. round 561 to the nearest 10 is 560.
Significant figure
Significant figures are the digits in a number that contribute to the accuracy of the number. The first significant figure is the first non-zero digit.
Degree of accuracy
A degree of accuracy shows how precise a number or measurement is. E.g to the nearest cm, nearest 10, 1 s.f., etc.
Significant figures
Significant figures are the digits in a number that contribute to the accuracy of the number. The first significant figure is the first non-zero digit.
Estimate
A quick estimate for a calculation is obtained from using approximate values, often rounded to 1 significant figure.
Overestimate
An estimate for a calculation which is greater than the exact answer.
Underestimate
An estimate for a calculation which is less than the exact answer.
Truncation
Truncation is when we simplifying a number by 'cutting off' one or more of the digits and replacing them with zeros if necessary to preserve place value.
Conjecture
A (mathematical) statement that is thought to be true but has not been proved yet.
Truncate
Truncation is the simplifying a number by 'cutting off' one or more of the digits and replacing them with zeros if necessary to preserve place value.

Many definitions from Oak National Academy (Open Government Licence).

When it's usually taught: Year 8 - Estimation and rounding; Year 10 - Rounding, estimation and bounds.

💼 Where it could take you

Jobs where people use this every day - whichever way you go after school.

Straight from school or an apprenticeship

With college or an advanced apprenticeship

With a degree

Each job opens its National Careers Service profile: what it pays, the hours, and how to get in.

📺 Watch a lesson on this

Each is a maths lesson by Oak National Academy licensed under Open Government Licence (OGL). Lessons open on Oak National Academy's site.

More on Number