Revision › GCSE Physics › Particle Model of Matter

Density and changes of state

GCSE Physics · Particle Model of Matter. Explained 3 ways - start with the one that suits you.

Density and changes of state Start here

You must know how to use the density formula and remember that mass never changes when a substance melts or boils.

Key words

density
mass per unit volume
kg m⁻³
standard unit for density
conserved
does not change during a physical process

Key points

  • Remember the formula: ρ = m/V.
  • Check units – density in kg m⁻³, volume in m³.
  • Convert cm³ to m³ by multiplying by 10⁻⁶.
  • Multiply density by volume to obtain mass.

Watch out for

  • Wrong conversion of volume gives an incorrect mass.

Remember: During a change of state the total mass stays the same, only the arrangement of particles changes.

Density and changes of state Core

Use this to remember the key ideas you must know for GCSE Science.

Key words

density
mass per unit volume, ρ = m/V (kg m⁻³)
particle model
explains how packing of atoms/molecules changes density across solids, liquids and gases.
phase change
physical change where mass is conserved; the substance returns to its original state if reversed.

Key points

  • Recall that density is calculated with ρ = m/V (kg per cubic metre).
  • Always convert any given volume into cubic metres before using it in the formula.
  • To find mass from density, rearrange the equation: m = ρV; remember mass does not change during a physical phase change.
  • Use the particle model to explain that tighter packing gives higher density – solids > liquids > gases is the usual trend, with notable exceptions such as ice being less dense than liquid water.
  • For irregular objects use displacement of fluid to find volume; for regular shapes calculate from measured dimensions.

Watch out for

  • Use the diagram if one is provided to confirm that the volume measured by the cylinder matches the ring’s displaced volume.
  • Check that all units are consistent before multiplying or dividing; mismatched units lead to incorrect results.

Remember: Mixing cm³ with m³ gives a 10⁶ error – the common mistake noted. Use correct conversion to get 9.46\(\times\)10^{-3}\,kg.

Density and changes of state Stretch

The density skill tests your ability to use the equation \(\rho = \frac{m}{V}\) with careful unit handling, recognise how particle packing affects density, and link density changes to phase transitions. In exam questions you must remember that mass is always conserved during a physical change and that densities are compared on the same SI basis (kg m⁻³).

Key words

density
mass per unit volume
SI units
kg for mass, m³ for volume

Key points

  • Write the density formula in the form \(\rho = \frac{m}{V}\).
  • Always convert any given volume to cubic metres before using it.
  • Insert the known density and converted volume into the formula; solve for the unknown quantity by rearranging algebraically if necessary.
  • Check that the final unit is kg – this confirms all conversions were correct.
  • Remember mass is conserved in melting, freezing, boiling, evaporation, condensation and sublimation – the total mass of the system does not change.

Watch out for

  • Common trap – using 0.44 cm³ directly as 4.4×10⁻¹ m³, which gives a mass that is five orders of magnitude too large.
  • Another mistake is to keep the volume in cm³ when the density is in kg m⁻³; the equation then returns kg cm⁻³, an incorrect unit.

Remember: In phase changes, temperature and state change while mass stays the same. Density follows a packing rule: solids are usually denser than liquids, which are denser than gases – except water where ice is less dense.

✏️ Try 3 quick questions

  1. What is the density of a material if it has a mass of 8 kg and a volume of 2 m³? Express your answer in kg/m³.

  2. The density of copper is 8.96 g/cm³. What is the mass of a 50‑cm³ sample?

  3. A sealed container holds 5.0 g of carbon dioxide gas that occupies a volume of 400 cm³. Calculate the density in kg / m³, rounded to one decimal place.

Practise it with real exam questions

4 Triangles has quick questions on density and changes of state, real GCSE past-paper questions with their mark schemes, and a revision plan that picks what to work on next.

Try the quick questions

📝 Worksheets and a knowledge organiser to print

Questions on this topic for a lesson, homework or revision - a quick "do now", misconception questions, small steps that change one thing at a time, and practice, with answers on the last page.

Easy Medium Hard 📄 Knowledge organiser

🔤 Key words to know

Density
the mass per cubic metre (m³) or cubic centimetre (cm³) of a material.
Vernier callipers
a device used to measure length precisely.
Micrometer
A device to measure length to very high precision.
Kilograms per cubic metre
the unit for density when mass is measured in kilograms (kg) and volume in cubic metres (m³), written as kg/m³.
Grams per cubic centimetre
the unit for density when mass is measured in grams (g) and volume in cubic centimetres (cm³), written as g/cm³.
Displacement can
A can with a spout used to measure the volume of a submerged object.

Many definitions from Oak National Academy (Open Government Licence).

When it's usually taught: Year 10 - Particle explanations of density and pressure; Year 10 - Energy of moving particles.

💼 Where it could take you

Jobs where people use this every day - whichever way you go after school.

Straight from school or an apprenticeship

With college or an advanced apprenticeship

With a degree

Each job opens its National Careers Service profile: what it pays, the hours, and how to get in.

📺 Watch a lesson on this

Each is a science lesson by Oak National Academy licensed under Open Government Licence (OGL). Lessons open on Oak National Academy's site.

More on Particle Model of Matter