Revision › Power and the National Grid › Worksheet

Power and the National Grid Easy

GCSE Physics · Electricity · Name ____________________ Date ________

Builds on: Mains electricity and safety, Current, potential difference and resistance, Series and parallel circuits

Do now

Quick questions on earlier topics - to get your brain going.

  1. A microwave consumes 1.2 kW and is used for 5 minutes each day for a week. How much energy, in joules, does it use in total? (Hint: 1 kW = 1000 W). [1]

  2. An electric heater uses 4 kW of power from mains. Calculate the current it draws (in A). Round to one decimal place. [1]

  3. A battery supplies 12 V. A resistor of unknown resistance is connected, producing a current of 0.4 A. Calculate the resistance using V = IR. [1]

  4. Which step should you do before measuring the resistance of a component with an ohmmeter? [1]

    1. ☐ Connect one lead across the component's terminals only
    2. ☐ Place the component in the circuit to maintain its temperature
    3. ☐ Heat the component to 100 °C
    4. ☐ Remove the component from any power supply and ensure it is disconnected from other circuits

Practice

  1. When measuring the voltage across a resistor with a multimeter, which setting should you use? [1]

    1. C) ACV 1000 V
    2. D) Continuity test
    3. B) DCV 200 V
    4. A) Auto‑range
  2. If a constant voltage supply is used and the resistance in a circuit increases, what happens to the power consumed by the load? [1]

    1. A) Power increases
    2. B) Power stays the same
    3. C) Power decreases
    4. D) Power first increases then decreases
  3. A circuit has a voltage of 12 V across a resistor with a resistance of 3 Ω. What power is dissipated by the resistor? [1]

  4. An appliance has a power rating of 200 W. If it runs for 30 min, how many kilowatt‑hours (kWh) of energy does it consume? [1]

  5. Which equation gives the power (in watts) in an electric circuit? [1]

    1. B) P = V × I
    2. D) P = I² × V
    3. C) P = V ÷ I
    4. A) P = V – I
  6. The transformer that raises voltage for transmission is called a ___ transformer. [1]

  7. A battery supplies 2 A of current to a device for 15 s. What is the charge transferred by the battery? [1]

  8. Power equals potential difference multiplied by ___? [1]

  9. Which symbol represents electric current in formulas? [1]

Stretch

A step up - try these if you finish.

  1. A small radio operates from a single‑cell battery that supplies 3 V and draws a current of 200 mA when it is turned on. What power (in watts) does the radio consume? Give your answer to one decimal place. [1]

  2. A standard electric kettle (2 kW) and a toaster (800 W) are used for exactly the same period of time. Which appliance uses more power per use? (a) Kettle (b) Toaster (c) Both use the same amount of power (d) It depends on the room temperature [1]

    1. d
    2. a
    3. b
    4. c
  3. Which of the following equations gives the power delivered to a circuit device? (a) P = V / I (b) P = I² × R (c) P = V × I (d) P = V × R [1]

    1. (c) P = V × I
    2. (b) P = I² × R
    3. (a) P = V / I
    4. (d) P = V × R
  4. A small electric motor runs at 4 A through a supply voltage of 220 V for 30 minutes each day. How many kilowatt‑hours of energy does it consume per day? Give your answer to two decimal places. [1]

Mixed practice

Questions on topics this one links to - mixing them helps you remember both.

  1. Which statement best defines a renewable energy source? A) It can be used once and then depleted B) It is not produced from natural processes C) It is replenished naturally over human timescales D) It only comes from fossil fuels [1]

    1. It only comes from fossil fuels
    2. It can be used once and then depleted
    3. It is replenished naturally over human timescales
    4. It is not produced from natural processes
    (Energy resources)
  2. Which statement about wind energy is incorrect? A) It can produce electricity when there is no sunlight. B) Its output depends on wind speed. C) It has a small land footprint. D) It emits CO₂ during operation. [1]

    1. It has a small land footprint.
    2. Its output depends on wind speed.
    3. It can produce electricity when there is no sunlight.
    4. It emits CO₂ during operation.
    (Energy resources)
  3. When measuring the resistance of a component with a multimeter, which precaution should you take? [1]

    1. Keep the device on while measuring to keep it warm.
    2. Touch both leads simultaneously for better contact.
    3. Disconnect the power supply before connecting the meter.
    4. Use the highest voltage setting on the meter.
    (Current, potential difference and resistance)
  4. In the equation Q = It, what does I stand for? [1]

    (Current, potential difference and resistance)
  5. In a series circuit, what quantity is the same through every component? [1]

    (Series and parallel circuits)
  6. Tick one box: Which statement about a series circuit is correct? [1]

    1. A) The total resistance equals the product of the resistances.
    2. B) The same current flows through every component.
    3. C) Each resistor has a different voltage drop regardless of size.
    4. D) The power supply's potential difference is divided equally among all components.
    (Series and parallel circuits)

💼 Where it leads: Smart meter installer · Electricity distribution worker · Electrician · Auto electrician - more

Stuck, or finished? Scan for help on power and the national grid - an explanation, hints and unlimited practice that marks itself.
Free at 4triangles.co.uk

Answers

  1. 2520000
  2. 17.4
  3. 30
  4. D ☐ Remove the component from any power supply and ensure it is disconnected from other circuits
  5. C B) DCV 200 V
  6. C C) Power decreases
  7. 48
  8. 0.1
  9. A B) P = V × I
  10. step‑up
  11. 30
  12. current
  13. I (ampere)
  14. 0.6
  15. B a
  16. A (c) P = V × I
  17. 0.44
  18. C It is replenished naturally over human timescales
    Renewable means it renews on a human timescale, so C is correct.
  19. D It emits CO₂ during operation.
    Wind energy produces power only where there is wind; it does not emit CO₂ in normal operation. Hence D is false.
  20. C Disconnect the power supply before connecting the meter.
  21. Current
  22. current
  23. B B) The same current flows through every component.

Some key word definitions from Oak National Academy (Open Government Licence).

Stuck, or finished? Scan for help on power and the national grid - an explanation, hints and unlimited practice that marks itself.
Free at 4triangles.co.uk