Revision › Power and the National Grid › Worksheet

Power and the National Grid Medium

GCSE Physics · Electricity · Name ____________________ Date ________

Builds on: Mains electricity and safety, Current, potential difference and resistance, Series and parallel circuits

Do now

Quick questions on earlier topics - to get your brain going.

  1. A microwave consumes 1.2 kW and is used for 5 minutes each day for a week. How much energy, in joules, does it use in total? (Hint: 1 kW = 1000 W). [1]

  2. An electric heater uses 4 kW of power from mains. Calculate the current it draws (in A). Round to one decimal place. [1]

  3. A battery supplies 12 V. A resistor of unknown resistance is connected, producing a current of 0.4 A. Calculate the resistance using V = IR. [1]

  4. Which step should you do before measuring the resistance of a component with an ohmmeter? [1]

    1. ☐ Connect one lead across the component's terminals only
    2. ☐ Place the component in the circuit to maintain its temperature
    3. ☐ Heat the component to 100 °C
    4. ☐ Remove the component from any power supply and ensure it is disconnected from other circuits

Practice

  1. A small radio operates from a single‑cell battery that supplies 3 V and draws a current of 200 mA when it is turned on. What power (in watts) does the radio consume? Give your answer to one decimal place. [1]

  2. A standard electric kettle (2 kW) and a toaster (800 W) are used for exactly the same period of time. Which appliance uses more power per use? (a) Kettle (b) Toaster (c) Both use the same amount of power (d) It depends on the room temperature [1]

    1. d
    2. a
    3. b
    4. c
  3. Which of the following equations gives the power delivered to a circuit device? (a) P = V / I (b) P = I² × R (c) P = V × I (d) P = V × R [1]

    1. (c) P = V × I
    2. (b) P = I² × R
    3. (a) P = V / I
    4. (d) P = V × R
  4. A small electric motor runs at 4 A through a supply voltage of 220 V for 30 minutes each day. How many kilowatt‑hours of energy does it consume per day? Give your answer to two decimal places. [1]

  5. A power station supplies a city via transmission line at 400 kV and delivers 500 MW of power. What is the current in the line? [1]

  6. A kettle is switched on and draws 12 A at a potential difference of 230 V for 3 minutes each time it is used. How many joules does the kettle transfer to the water per use? Give your answer as an integer number of joules. [1]

  7. When measuring the voltage across a resistor with a multimeter, which setting should you use? [1]

    1. C) ACV 1000 V
    2. D) Continuity test
    3. B) DCV 200 V
    4. A) Auto‑range
  8. If a constant voltage supply is used and the resistance in a circuit increases, what happens to the power consumed by the load? [1]

    1. A) Power increases
    2. B) Power stays the same
    3. C) Power decreases
    4. D) Power first increases then decreases
  9. A circuit has a voltage of 12 V across a resistor with a resistance of 3 Ω. What power is dissipated by the resistor? [1]

  10. An appliance has a power rating of 200 W. If it runs for 30 min, how many kilowatt‑hours (kWh) of energy does it consume? [1]

  11. Which equation gives the power (in watts) in an electric circuit? [1]

    1. B) P = V × I
    2. D) P = I² × V
    3. C) P = V ÷ I
    4. A) P = V – I
  12. The transformer that raises voltage for transmission is called a ___ transformer. [1]

Stretch

A step up - try these if you finish.

  1. Which of the following statements about transformers is false? (Choose one) [1]

    1. A) A step‑up transformer increases voltage and decreases current in the transmission line.
    2. B) A step‑down transformer reduces voltage for domestic use, increasing current proportionally.
    3. C) Transformers are lossless devices; all electrical energy is transferred from primary to secondary.
    4. D) The ratio of voltages equals the ratio of turns on the windings.
  2. When power is transmitted over long distances at high voltage, which of the following statements is true? (Choose one) [1]

    1. B) The voltage drop across the cable is larger, reducing efficiency.
    2. A) The current in the cable is higher, increasing I²R losses.
    3. D) Both voltage and current remain unchanged compared to domestic supply.
    4. C) The current is lower, so resistive losses are smaller.
  3. A 60‑W lamp is left on for 3 h each day during a week (7 days). How many joules of energy does it use over the week? Give your answer in J with no exponent. [1]

  4. Which of the following correctly describes the relationship between the power of a resistive heater, its potential difference and its current? (Choose one) [1]

    1. A) P = V² ÷ I
    2. C) P = I ÷ V
    3. B) P = V × I
    4. D) P = V + I

Mixed practice

Questions on topics this one links to - mixing them helps you remember both.

  1. Which statement is FALSE about solar photovoltaic panels? [1]

    1. (d) They produce energy at night without sunlight
    2. (a) They generate electricity when the sun is shining
    3. (b) They can be connected to batteries for night use
    4. (c) They require no fuel
    (Energy resources)
  2. Tick one box. Which statement best describes an Ohmic conductor? [1]

    1. Its resistance decreases as temperature rises
    2. Its resistance remains constant for a given temperature and voltage
    3. Its resistance increases as current increases
    4. Its resistance remains constant regardless of temperature
    (Current, potential difference and resistance)
  3. A hair dryer draws a current of 4 A from the mains supply. Calculate its power consumption. Use \(P = V\times I\) where \(V = 230\,V\). [2]

    (Mains electricity and safety)
  4. A country produced 400 TWh of electricity from hydro over a year, but this year it increased to 520 TWh due to higher rainfall. What is the percentage increase? [1]

    (Energy resources)
  5. Adding a second resistor in series to an existing circuit will _______. [1]

    1. C) decrease the total current from the battery
    2. D) double the resistance of each individual resistor
    3. A) increase the total current from the battery
    4. B) leave the voltage across each component unchanged
    (Series and parallel circuits)
  6. Which component in a plug protects the appliance from over‑current? [1]

    1. Neutral wire
    2. Earth wire
    3. Live wire
    4. Fuse
    (Mains electricity and safety)

💼 Where it leads: Smart meter installer · Electricity distribution worker · Electrician · Auto electrician - more

Stuck, or finished? Scan for help on power and the national grid - an explanation, hints and unlimited practice that marks itself.
Free at 4triangles.co.uk

Answers

  1. 2520000
  2. 17.4
  3. 30
  4. D ☐ Remove the component from any power supply and ensure it is disconnected from other circuits
  5. 0.6
  6. B a
  7. A (c) P = V × I
  8. 0.44
  9. 1250
  10. 496800
  11. C B) DCV 200 V
  12. C C) Power decreases
  13. 48
  14. 0.1
  15. A B) P = V × I
  16. step‑up
  17. C C) Transformers are lossless devices; all electrical energy is transferred from primary to secondary.
  18. D C) The current is lower, so resistive losses are smaller.
  19. 4536000
  20. C B) P = V × I
  21. A (d) They produce energy at night without sunlight
  22. B Its resistance remains constant for a given temperature and voltage
  23. 920
  24. 30
  25. A C) decrease the total current from the battery
  26. D Fuse

Some key word definitions from Oak National Academy (Open Government Licence).

Stuck, or finished? Scan for help on power and the national grid - an explanation, hints and unlimited practice that marks itself.
Free at 4triangles.co.uk